|
Notes |
|
|
|
|
|
|
(0001019)
|
|
MrSugarCube
|
12-04-11 01:18
(edited on: 12-04-11 01:19) |
|
If you reenter design mode and press the 'Synch' button, is the hole still there?
I've tried following your steps here (and the video's, which are slightly different) but the dirt doesn't disappear. I do get a weird display issue though where if I target the top of the stairs then a new line of dirt appears on the 2nd floor, but this disappears as soon as I press 'Synch', 'Commit' or exit design mode (I suspect in my case it could be an issue with client 7.0.13.2).
|
|
|
|
|
Yes, in addition to the steps to reproduce are less, hehe.
1º Enter design mode
2º Create stairs
3º Remove
4º Synch || Close design mode || Commit
Here i use the client 7.0.8.2 |
|
|
|
(0001021)
|
|
MrSugarCube
|
12-04-11 02:21
(edited on: 12-04-11 02:29) |
|
Could you try disabling the house menu + triggers (@HouseDesignCommit), and instead use '.xlink.customize' to design the house (target the sign) to see if this still happens? I'm still not able to get the dirt to disappear here (just tried with 6.0.1.6 too).
"4º Synch || Close design mode || Commit"
You can also reproduce it by closing design mode without committing?
|
|
|
|
|
Problem persist. Tomorrow I'll try with a clean installation of sphere to see.
"4º Synch || Close design mode || Commit"
You can also reproduce it by closing design mode without committing?
Sorry, only with commit or synch. |
|
|
|
|
Nobody else has this problem?. Mostly because if I have to keep looking for a solution.
Thanks. |
|
|
|
|
|
I can't reproduce this with the default scp pack. Clean install, nightly. |
|